oldvur.blogg.se - Mac ethernet no working

In the Network system preferences window, click Apply to finish the configuration.Click OK to close the TPC/IP preferences window.In the Configure IPv6 field, select Automatically.In the Configure IPv4 field, select Using DHCP.

Click the TCP/IP tab and enter the following:.

Click the lock, located in the bottom left corner of the window, if it is closed and authenticate using your administrator name and password.

In the Network system preferences window, make sure that Ethernet is selected.

Once you have registered your computer for network access, you can follow these steps to complete the configuration: Note: You will not be able to use your computer on the network until your connection information has been registered.

Off-campus students should include this information in a HelpSU request.

On-campus students need to register their Ethernet ID online via the Student Technology Specialists Website.

Faculty and staff should provide this information to their Local Network Administrator (LNA).

Write down the displayed Ethernet ID and then click OK. In the Network system preferences window, make sure that Ethernet (in the left panel) is selected.In the Internet & Network section, click Network. If you already know your hardware Ethernet ID and have provided it to your Local Network Administrator or Peer Technology Specialists, you can skip to Configuring for Ethernet connection.Ĭlick the System Preferences icon in the dock. You must register your computer's hardware Ethernet ID before your computer can communicate over SUNet.